InMoov – Custom Circuit Board has arrived

As you may have seen in a previous post I designed a custom circuit board for connecting the Adafruit NeoPixel Ring to the Arduino based on the notes within the sketch stating that it is recommended to add a capacitor and a resistor to prevent damage to the LED’s from a power surge.

Today the boards arrived and I couldn’t be more pleased with them.  I immediately soldered the components on one of the boards so I could give it a test and see how it looks.

Below is a picture of the boards that I received as well as a picture of one of them all wired up.  Also note, I have at least 10 extras that I am willing to sell if anyone has an interest in connecting one up to their NeoPixel LED Ring.  They don’t need to be used specifically for the InMoov Robot.


NOTE:  I am not the creator of this robot.  The InMoov Robot was created by Gael Langevin, you can read more about it here:

Leave a Reply